|
Estetic S
sel-curing acrylic resin for repairing dentures and orthodontic bases
Available in packages:
- 100 g powder veined - pink "10"
50 ml Monomer Estetic S solvent
- 100 g powder not veined - pink "10"
50 ml Monomer Estetic S solvent
- 100 g powder neutral color "0"
50 ml Monomer Estetic S solvent
|
- 100 g powder veined "8V"
50 ml Monomer Estetic S solvent
- 100 g powder not veined "8"
50 ml Monomer Estetic S solvent
|
Estetic S
- self-curing polymer
- its colour match to the Estetic colour
- complies with the requirements of international standard EN ISO 1567:1995
Mixing proportions:
Recommended powder/solvent mixing proportions - 2:1 w/w
Direction for use and polymerising:
Pour an appropriate amount of the solvent into a vessel and gradually add powder up to complete saturation with the solvent. Stir for a few seconds - solution should have the consistency of thick cream.
Cover the vessel tightly and keep under cover for 2 to 5 min (depending on the temperature
of the environment). Higher temperatures accelerate and lower delay initial swelling. Check plasticity with a spatula - if we consider the acrylic mass to attain the highest plasticity level (just after the phase of "drawing thread") the material is ready for use. Apply the plastic mass onto the surface prepared for repair and form under gradually increased pressure in a polymerizing mould. Polymerize in water at 40-50°C under 2-6 bar pressure for about 20 minutes. After polymerization process, polish according to commonly used methods.
The manufacturer recommends the following guidelines to be included in the instructions for the patients:
- dentures should be washed with a tooth-brush and toothpaste or any other agents especially designed for the care of such products,
- don`t soak them in heavily alkali or acid substances in order to avoid damaging of surface,
- damaged dentures should be repaired only by a dental technician or a dentist,
- the adjustment of dentures should be regularly checked.
|
