Estetic Special
self-curing acrylic resin for temporary crowns and bridges

Available in packages:

• 12.5 g of A2, B3, G1, G2, N3, R1, R5, ENAMEL powders
  Total 100g powder, 50 ml Estetic Special solvent
• 12.5 g of A1V; A2V; A3V; A4V; B2V; C2V; D3V, ENAMEL powders
  Total 100g powder, 50 ml Estetic Special solvent
  
• Also single colors available in packages containing 100 g powder (DENTIN 75g, ENAMEL 25g) and 50 ml solvent

Estetic Special

• self-curing polymer
• its elasticity and durability render it suitable for extensive temporary bridges
• a wide range of shades makes it possible to obtain the colour that ideally imitates the natural colour of teeth
• meets the requirements of PN-EN ISO 10477:2002 standards.

Mixing proportions:

Recommended powder/solvent mixing proportions - 2:1 w/w

Direction for use and polymerising:

Pour an appropriate amount of the solvent into a vessel and gradually add powder up to complete saturation with the solvent. Stir for a few seconds - solution should have the consistency of thick cream.
Cover the vessel tightly and keep under cover for 2 to 5 min (depending on the temperature of the environment). Higher temperatures accelerate and lower delay initial swelling. Check plasticity with a spatula - if we consider the acrylic mass to attain the highest plasticity level (just after the phase of "drawing thread") the material is ready for use. Apply the plastic mass on the surface of the model and form under gradually increased pressure in a polymerizing mould. Polymerize in water at 40-50oC under 2 bar pressure for about 10 minutes. After polymerization process, polish crowns and bridges according to commonly used methods.

The manufacturer recommends the following guidelines to be included in instructions for the patients: